I configured my program to run as a trial for 10 Executions, and after the 10 execution, the registration box open, but I clicked on RUN, and the program loaded. After closing the program out, I clicked on RUN again, and the program loaded again. Please tell me how I can prevent that from happening because the program is not protected when this happens.
Bigkang
Program not protected
Re: Program not protected
Hi Bigkang,
You should go to Registration Features - Registration Dialog panel and click Design Dialog button. Then, you need to delete Try button from this form.
Also, I think that you did not specified the option Trial Control - Limitation by Executions - Terminate when Expired. This option closes the program after trial expired.
Note, trial works only until program is not registered. Once the program is registered with the valid key the trial stops to work, this is the logic of trial limitations. Make sure your testing copy is not registered. To delete registration information from local computer open your project in Enigma Protector, go to main menu - Tools - Debug - Reset all Local Info.
You should go to Registration Features - Registration Dialog panel and click Design Dialog button. Then, you need to delete Try button from this form.
Also, I think that you did not specified the option Trial Control - Limitation by Executions - Terminate when Expired. This option closes the program after trial expired.
Note, trial works only until program is not registered. Once the program is registered with the valid key the trial stops to work, this is the logic of trial limitations. Make sure your testing copy is not registered. To delete registration information from local computer open your project in Enigma Protector, go to main menu - Tools - Debug - Reset all Local Info.